Remedies For Paper Out Error - Epson Stylus PHOTO 1270 Service Manual

EPSON Stylus Photo 870/1270

3.1.1.3 Remedies for Paper Out Error

This section provides checkpoints and corresponding actions to take
when a Paper Out error occurs for either of the following reasons:
!
Paper is set in the ASF hopper but not fed.
!
Paper is loaded but not detected by the PE sensor actuator.
Be sure to follow the steps in the order listed in the table.
NOTE: If the exhibited problem is similar to a problem listed under
"Problem", take the actions in the right column. If not, proceed to the
next step.
TROUBLESHOOTING
Table 3-5. Remedies for Paper Out Error
Step Problem
1 Load/Eject button is
pressed but paper is
not loaded even
when the ASF LD
rollers turn, and a
Paper Out error is
displayed.
2 The Load/Eject
button is pressed
and the ASF LD
rollers turn. But
they turn again to
send paper beyond
TOP position. Then
a Paper Out error is
displayed.
Overview
Check & Actions
1. Set a cleaning sheet in the ASF up side down.
2. Holding the top edge, press the Load/Eject
button to remove micro pearl from the paper
load roller.
To remove severe soiling, staple a cloth
moistened with alcohol to a postcard and clean
the roller in the same manner.
CL Sheet
Base Sheet Base Sheet
Non-adhesive Area Non-adhesive Area
(Postcard) (Postcard)
Adhesive Area
Staples
This side down
Cloth moistened
with alcohol
Check if the connector (yellow, 3-pin) for the PE
sensor is connected to PE sensor or CN5 on the
Main Board.
PE Sensor
Connector
Torsion Spring
<Printer Bottom>
Revision B
60