Epson Stylus PHOTO 1270 Service Manual page 86

EPSON Stylus Photo 870/1270
A D J U S T M E N T
When you replace the Printhead Unit, perform the
R E Q U I R E D
following adjustments:
1. Initial ink charge (Refer to Chapter 5/Section 5.1.1.)
2. Head Voltage ID Input (Refer to Chapter 5/Section
5.1.2.)
3. Head Angular Adjustment (Refer to Chapter 5/Section
5.1.3.)
4. Bi-D Adjustment (Chapter 5 /Section 5.1.4.)
!
When installing FASTENER, HEAD, first fasten the two
C H E C K
screws (CBP, 3x6) securing FASTENER, HEAD and the
P O I N T
CBB Sems W2 (M2.5x6) temporarily, and then attach the
torsion spring. After that, fasten the screws tightly.
!
When installing FASTENER, HEAD to the Carriage Unit,
fasten the screws in the following order:
1) CBP (3x6) on the right
2) CBP (3x6) on the left
3) CBB Sems W2 (M2.5x6)
Disassembly And Assembly Disassembly Procedures
Revision B
86