Pe Sensor Unit Removal - Epson Stylus PHOTO 2000P Service Manual

EPSON Stylus PHOTO 2000P

4.2.15 PE Sensor Unit Removal

1. Remove HOUSING. (Refer to Section 4.2.1)
2. Remove the ASF Unit. (Refer to Section 4.2.10.)
3. Remove the DE Unit. (Refer to Section 4.2.9.)
4. Remove PAPER GUIDE, RIGHT Unit. (Refer to Section 4.2.13.)
5. Remove the timing belt. (Refer to Section 4.2.11.)
6. Release the two hooks securing the PE sensor unit to FRAME, TOP, lift
up the PE sensor unit, and then remove it to the rear.
Hooks
PE Sensor Unit
Figure 4-66. PE Sensor Unit Removal
C H E C K
When installing the PE Sensor Unit, ensure that the
P O I N T
sensor lever is set in the square hole in PAPER GUIDE,
RIGHT Unit. (See Figure 4-59.)
DISASSEMBLY AND ASSEMBLY Disassembly Procedures
Revision A
117