Remedies For Paper Out Error - Epson Stylus PHOTO 2000P Service Manual

EPSON Stylus PHOTO 2000P

3.1.1.3 Remedies for Paper Out Error

This section provides checkpoints and corresponding actions to take
when a Paper Out error occurs for either of the following reasons:
Paper is set in the ASF hopper but not fed.
Paper is loaded but not detected by the PE sensor actuator.
Be sure to follow the steps in the order listed in the table.
NOTE: If the exhibited problem is similar to a problem listed under
"Problem", take the actions in the right column. If not, proceed to the
next step.
TROUBLESHOOTING
Table 3-5. Remedies for Paper Out Error
Step Problem
1 Load/Eject button is
pressed but paper is
not loaded even
when the ASF LD
rollers turn, and a
Paper Out error is
displayed.
2 The Load/Eject
button is pressed
and the ASF LD
rollers turn. But
they turn again to
send paper beyond
TOP position. Then
a Paper Out error is
displayed.
Overview
Check & Actions
1. Set a cleaning sheet in the ASF up side down.
2. Holding the top edge, press the Load/Eject
button to remove micro pearl from the paper
load roller.
To remove severe soiling, staple a cloth
moistened with alcohol to a postcard and clean
the roller in the same manner.
CL Sheet
Base Sheet Base Sheet
Non-adhesive Area Non-adhesive Area
(Postcard) (Postcard)
Adhesive Area
Staples
This side down
Cloth moistened
with alcohol
Check if the connector (yellow, 3-pin) for the PE
sensor is connected to PE sensor or CN5 on the
Main Board.
PE Sensor
Connector
Torsion Spring
<Printer Bottom>
Revision A
60