Changing The Form Set - Duerkopp Adler 743-221 Operating Instructions Manual

2.12 Changing the Form Set

16
1 2
A form set corresponding to the desired seam form must be inserted.
Form set 0793 078001 =
Form set 0793 078002 =
Form set 0793 078034 =
Form set 0793 078xxx =
Caution Risk of Injury !
Turn the main switch off.
The form set may only be changed with the sewing unit turned off.
Taking the form set out
–
Turn the handwheel until the needle lies in the 2nd position (OT).
–
Push the form set into the left end position.
–
Turn handle 1 approx. 90° counterclockwise.
–
Lift the form set 2 on the left side and carefully loosen from the
transport carriage.
–
Remove the form set.
Inserting the form set
–
Turn the handwheel until the needle lies in the 2nd position (OT).
–
Push the transport carriage into the left end position.
–
Carefully place the right side of form set 2 onto the transport
carriage.
–
Turn handle 1 approx. 90° counterclockwise and place the form set
completely on the the transport carriage.
–
Turn handle 1 back.
The form set is locked and sits firmly on the transport carriage.
–
Position the press-on cylinder 4 with the guide roller on the guide
curve 3.
–
Push the form set to the right stop.
3
Straight seam
Curved seam
Curved seam for pleats
Customer-specific version
4