Disassembling The Fusing Unit; Heater Lamp Removal - Epson EPL-5700 Service Manual

EPL-5700

4.2.17 Disassembling the Fusing Unit

If you need to disassemble the fusing unit because of image quality
problems and defective parts, follow the procedure below.

4.2.17.1 Heater Lamp Removal

1. Remove the fusing unit. (See section 4.2.16)
2. Remove two CSB screws(3x8) securing the fusing unit.
3. Release the right and left hooks connecting the fusing unit, and separate
the fusing unit.
CSB(3x8)
Figure 4-24. Separation of the Fusing Unit
Rev. A
4. Remove the backup roller.
5. Refer to Figure4-25. 1)Move the front fusing guide board to the left side
CSB(3x8)
once, 2)remove the right side of the guide board, 3) remove the left side
of the guide board.
(1)
(3)
Front Fusing Guide
Figure 4-25. Backup Roller and Front Fusing Guide Removal
Chapter4 Disassembly and Assembly
Back up Roller
(2)
4-19