Details Of Disassembling/Assembling By Parts/Unit - Epson Stylus NX125 Service Manual

Epson Stylus NX125/T13/NX130 series
1.3

Details of Disassembling/Assembling by Parts/Unit

Panel Unit (NX125/NX130 series)
Panel Unit
Panel FFC
Do not lift the Panel Unit too fast, since the Panel FFC is connected
to the back of the Panel Unit.
CIS (NX125/NX130 series)
Spacer
Be careful not to lose the Spacer because it comes off easily when disassembling the CIS.
 When installing the spacers, be sure to place them with the cutout facing inward.
 Align the toothed side of the Timing Belt with the same shaped rib of the backside of the CIS, and secure the Timing Belt with Torsion Spring.
Disassembly/Assembly
Document Pad (NX125/NX130 series)
Document Cover
Document Pad
Origin Position
Standard line
Double-sided tape
When installing the Document Pad, follow the procedure below.
1. Place the Document Pad with the side where the double-sided
tape attached upward on the document glass aligning its corner
with the origin position.
2. Close the Document Cover to attach the Document Pad.
Backside of the CIS
CIS
Torsion Spring
Details of Disassembling/Assembling by Parts/Unit
Scanner
Unit
Panel FFC
Do not lift the Scanner Unit too fast, since the Panel FFC, Scanner Motor cable and Scanner FFC are connected to the rear side of the Scanner Unit.
Tighten the screws in the order indicated in figure above.
Timing Belt
Main Board
Toothed
side
PE Sensor Lever
Take care not to damage the PE Sensor Lever.
Align the ribs (x3) of the Main Frame with the cutouts of the Main Board.
Scanner Unit (NX125/NX130 series)
1
Scanner FFC
Scanner Motor cable
3
Main Board
Revision F
2
4
Scanner Unit
C.B.P-TITE SCREW 3x10 (5.0 ± 0.5 kgf·cm)
Main Board
Rib
16
Confidential