List Of Panel Setting - Epson EPL-5700 Service Manual

EPL-5700
Y
Memory LED(yellow): Displays a non-flashing light when either a
Print Overrun or Mem Overflow error has
occurred. Flashes when the resolution is
reduced from 600 to 300 dpi, because of lack
of memory size.
Refer to Chapter 3 for error conditions.
CAUTION
This printer has EEPROM to maintain the function
setting. Data-writing to EEPROM can not be
guaranteed, if the power is turned off during
writing. Therefore, sometimes service error call
occurs or the panel setting returns to the initial
setting by all reset or at the next power on. In
order to prevent this, do not turn off the printer at
the following conditions, since data-writing to
EEPROM is performed.
From the power is turned on until the On Line
light stays on.
When On-line light is flashing.
Rev. A

1.3.3 List of Panel Setting

This printer has no LCD display in the control panel, so it is not possible to
make function settings from the control panel, excluding toner left quantity
reset and OPC drum life reset by the special operation and status sheet.
Function settings can be performed using "RCP"(remote control panel).
In the Table below, note that the bold and italic value in the "Value" column
indicates the factory default setting.
Table 1-9. Function Setting for Control Panel
Menu Item
Test Menu
Status sheet
ESC/Page Font
Sample.
LJ4 Font Sample.
ESCP2 Font
Sample.
FX Front Sample
1239X Front
Sample.
PS Status Sheet
PS Font Sample
PS Fact Sheet
Emulation
Parallel
Menu
Serial
*2
AUX
Printing
Paper Source
Menu
Page Size
Wide A4
Orientation
Copies
Manual Feed
Resolution
Skip Blank Page
Chapter1 Product Description
Value
*1
*1
*1
*1
LJ4 , ESCP2, I239X, PS
AUTO
*3
Auto , MP, LC1 .
*10 *17
A4 , A5, B5, LT , HLT,
LGL, GLT, GLG, EXE, F4,
MON, C10, DL, C5, C6, IB5,
CTM.
Off, ON
Port , Land
1 -999
Off, On
600, 300
*14
Off , On
, GL2,
1-9