Eprom Seam Parameters; Setting The Seam Sequence; Copying Seam Numbers; Erasing Seams - Duerkopp Adler 2211-5 Working Instructions

Short Seam Automat 2211-5 Working Instructions
D.3
D.3.1 System menu

Eprom seam parameters

This function allows to copy the factory-programmed fi-
xed seams from the Eprom back to the sewing program.
• Press key.
• Press key (init parameters).
• Press key (Eprom seam parameters).
• Enter seam number 01 using numeric keypad.

Setting the seam sequence

The settings refer to the selected sewing program. The
sequence for sewing the seams can be set at will. When
the sequence is set, existing seam numbers are overwrit-
ten or new seam numbers are written.
• Press key.
• Press key.
The display shows the marking of the sewing program and
the seam numbers.
20 01 02 03
Mark seam number to be changed using cursor:
20 01 02 03
• Press key.
Enter new seam number using numeric keypad:
20 01 04 03
Confirm input and exit menu:
• Press key.
The display shows the new seam sequence.
20 01 04 03
Programming
04
04
04
04
D.3.1 System menu

Copying seam numbers

Use this function to copy the properties of a factory-pro-
grammed sewing program or of your self-configured se-
wing programs into an other sewing program. During the
copying process, all seams of a sewing program are trans-
ferred so that the existing properties of a sewing program
will be overwritten completely..
1. Request sewing program (destination) and mark desi-
red seam number (source).
• Press key.
2. Enter two-digit seam number using numeric keypad.
• Press key.
• Press key (init parameters).
• Press key (copy seam number).
• Enter two-digit seam number using numeric keypad.
The display shows *O.K. PLEASE WAIT* to indicate that
the copy process has been successfully completed.

Erasing seams

Request sewing program and mark seam number to be
erased using cursor (seam number is underlaid black).
• Press or
• Press key.
• Press key (init parameters).
• Press key (erase seam).
• Enter seam number using numeric keypad.
Confirm safety prompt, press
NOTE - Deleting seam numbers!
If a seam number is deleted, it is removed from all se-
wing programs into which it had been inserted.
- D 77 -
Beisler Automated Sewing Equipment
key
key.