Attaching The Material Stopper By Primary Seams; Setting The Seam Interval By Primary Seams - Duerkopp Adler 744-122 Operating Instructions Manual

2.2 Attaching the material stopper by
primary seams
Turn main switch off!
- Risk of Injury -
– The contours of the material stopper and the
material guide rail must agree in the transport
carriage's right hand position.
– Turn the star grip 7 back several turns.
– Slide the holder plate 5 under the star grip 7 in
such a manner that its cutout is exactly seated
on the collar bolt and the hole locks above the
location peg 6.
2.3 Setting the seam interval by pri-
mary seams
The uniform gap between material guide rail and
material stopper, that is, the planned seam interval,
is to be set after loosening the screws 4.
6
– Screw the star grip 7 tight.
– When equipped with material holder 1 on the
material stopper its compressed air hose
should be plugged into the pneumatic socket 3.
– The coding plug_2_is always to be plugged into
the socket 8_.
It contains the coding for the allowable rail
return speed.
1
3
2
8
4
7 6 5