Fitting The Belt Guards - Duerkopp Adler 888 Instruction Manual

4.3

Fitting the belt guards

1
2
3
12
–
Disassembly the hand wheel (1).
–
In the machines with the motor on the table top mount the
guard (2) on the machine head (the guard is included in of the
motor part set) and mount the guard (3) on the motor (the guard is
included in the motor package).
–
In the machines with the motor on the sewing head and with
1,55:1 toothed belt driving gear, mount the proximity switch (6). It
is included in the "kit for motor".
–
In all machines with the motor on the machine head mount the
guards (4) and (5) (they are included in of the motor part set).
–
Mount the hand wheel (1). Doing this, observe the correct angle
position: if the needle is in the upper dead point, there should be
the 0° value on the hand wheel scale.
1
4
5
6