6.2.3
Checking of set positions
6.3
Master reset
Position 1
–
Switch on the network switch.
–
Tread the pedal forwards shortly and release. The machine is
stopped in the position 1 (see chapter 6.2.1).
–
Check the angle on the hand wheel scale (225° ± 5°).
Position 2
–
Tread the pedal forwards shortly at first and then entirely
backwards with the heel until the machine stops. The machine
stops in the position 2 (see chapter 6.2.1).
–
Check the angle on the hand wheel scale (35° ± 5°).
By means of the so-called master-reset all changed values are set
back to the preset ones again.
How to proceed with the master reset is described in the instructions
of the motor manufacturer Efka.
GB
25