5.6
Fitting the belt cover
1
2
16
–
Remove the handwheel 1.
–
When the machine's motor is situated underneath the table plate
mount the belt cover 2 on the machine head .
(The belt cover is part of the drive package)
–
When the machine's motor is situated on the sewing machine head
mount the belt cover 4 and 5 .
(The belt guard is part of the drive package)
–
Mount the handwheel 1. Pay attention to the correct position:
The position of the needle in its upper dead center must
correspond to the value "0" on the handwheel's graduated scale.
1
4
5