Machine-Specific Parameters; Masterreset - Duerkopp Adler 868 Instruction Manual

Hide thumbs Also See for 868:

Table of Contents

6.8.8

Machine-specific parameters

6.8.8.1

General

6.8.8.2

Autoselect

6.9

Position 2

–

First push the pedal forward and then completely backwards.

–

The needle positions in position 2 ( about 66° on the handwheel).

–

Check the needle position.

If one or both needle positions are not correct then carry out the

correction of the needle position. (see operating instructions)

The functions of the sewing-drive control are determined by the

program and the parameter settings.

Prior to delivery all parameter values have been correctly preset for

each particular class and subclass. For this purpose some preset

values of the control unit have also been altered (for example the

maximum speed). When exchanging the control unit the

machine-specific parameters have to be reset correctly. (see

operating instructions)

The control unit "recognizes" by measuring the Autoselect resistance

in the machine which machine series has been connected. Autoselect

selects the control functions and the pre-set parameter values.

Caution !

If the control fails to recognize a valid Autoselect resistance (or any at

all), the drive runs only with the so-called emergency operating

functions to prevent machine damage

By effectuating a masterreset all parameter values are reset to the

pre-set values. After a masterreset all machine-specific parameters

have to be corrected again.

Table of Contents