Default Setting Function; Eeprom Clear Function; Table 1-45 Eeprom Initialization Settings - Epson FX-2170 Service Manual

FX-2170 Service Manual

1.4.7 Default Setting Function

Pressing the button while turning on the printer puts the printer in default setting mode. Some default
printer settings can be changed in this operation. The method for setting defaults is described in the
instruction sheets, which are printed out immediately after you enter the mode. You are asked to use three
buttons ( , , and
: 1 LED) on the control panel. Refer the instructions printed in default setting mode for the actual
method used to set defaults.

1.4.8 EEPROM Clear Function

Pressing the and
standard factory settings. This operation initializes the items below to the factory settings in the right-hand
column.

Table 1-45 EEPROM Initialization Settings

Setting
Font
Pitch
Character Table
Page Format
( Tractor Rear / Front )
Page Format
(Friction , CSF Bin 1 / Bin 2 ,
Manual Feed Rear / Front )
Print Direction
Auto LF
Auto Tear-Off
1-inch Skip
High Speed Draft
Input Buffer
BDC-ST Reply
I/F Selection
Auto I/F Wait Time
Software
Slashed Zero
Buzzer
Auto CR ( IBM Mode )
Adjust Tear-Off Position
Paper Conditions
Rev.A
) and watch six LEDs (
buttons while turning on the printer resets the EEPROM to the
Roman
10 CPI
PC437
Page Length:
TOF Position:
Bottom Margin :
Page Length:
TOF Position:
Bottom Margin:
Bi-d
Off
Off
Off
On
On
On
Auto I/F Mode
10 sec.
ESC/P
Off
On
Off
0 inch
Friction: Bin 1 , Tractor: Tear-Off: Status Off
Product Description
: 3 LEDs,
Factory Default
11 inches
8.5 mm (0.333 inches)
11 inches
22 inch
8.5 mm (0.333 inch)
22 inches
: 2 LEDs, and
1-33