FX-2170 Service Manual
2.
Remove the right sub frame from the right frame assembly.
3.
Remove the following 11 parts from the right frame assembly.
2 compression springs (200 g) 2 plain washers
2 spur gears (34.5 mm)
1 combination gear (8 mm, 31.5 mm)
Adjust the bidirectional print alignment. Refer to Chapter 4.
Mount the 11 parts above on the right frame assembly, as shown in the following figures.
Compression Spring (200g)
Plan Washer
Rev.A
1 spur gear (34 mm) 1 spur gear (21 mm)
1 intermittent gear
Compression Spring (200g)
Plan Washer
Figure 3-23 Engaging Gears 1
Disassembly and Assembly
1 spur gear (27 mm)
Spur Gear (27mm)
Spur Gear (34.5mm)
Spur Gear (34mm)
Spur Gear
(21 mm)
Super Gear
(34.5 mm)
Combination Gear
(8mm/ 31.5mm)
Intermittent Gear
3-17