21. Clamping Plates
21.1 Setting Parallel to the Material Support Plate
1
2
21.2 Setting the Stopper Pieces
The clamping plates should lie parallel to the edge 2 and 7 of the
material support plate.
Caution Risk of Injury !
Pull the mains plug before setting.
–
Place the right clamping plate on the material support plate.
–
Set the stopper piece 6 back.
–
Loosen screw 4.
–
Press the clamping plate so far to the right until it lay onto the edge
7 of the material support plate along the whole length.
–
In this position press screw 4 onto the clamping plate and screw
tight.
–
If the clamping plate moves back up to the stop 5 then there must
be an equal clearance between it and the edge 7 along the whole
length.
–
Set the left clamping plate in the same way.
–
Place both clamping plates.
–
Turn the hand crank until the rollers under the clamping plates are
at the highest point of the spreading block 3. Both clamping plates
are spread sideways in this position.
–
Align the clamping plates sideways on the material support plate
so that an equal clearance exists to the left edge 2 and to the right
edge 7.
–
Set the stopper pieces 1 and 6 tight to the clamping plates and
tighten the screws again.
3
4
5
6
7
27