Changing Buttonhole Parameters; Automatic Or Manual Operation (Can Only Be Set In Sequence Mode) - Duerkopp Adler 579 Operating Instructions Manual

9.4.3

Changing buttonhole parameters

9.4.4

Automatic or manual operation (can only be set in sequence mode)

The main parameters of the buttonhole are displayed on the main
screen.
Changing the parameters
Use the ñ and ò cursor keys to select the line containing the
–
parameter to be changed.
Press OK.
–
Change the parameter value.
–
Press enter to accept the changed value.
–
If the new value is not to be accepted, press "ESC".
–
Depending on the setting the machine operates either manually or
automatically.
Automatic operation
Arrows are displayed between the buttonhole shapes in the sequence
displayed.
After a buttonhole has been completed the controller switches
automatically to the next shape. After the last buttonhole has been
completed the controller switches back to the first buttonhole in the
sequence.
The current buttonhole is marked with a bar.
Manual operation
No arrows are displayed between the buttonhole shapes in the
sequence displayed.
The controller does not switch automatically between the buttonhole
shapes.
The current buttonhole is marked with a bar.
Switching between automatic and manual operation
Use the ñ and ò cursor keys to select the line containing the
–
current sequence.
Press OK.
–
Use the ñ and ò cursor keys to switch between the two operating
–
modes.
The arrows between the buttonhole shapes appear and disappear
accordingly.
Selecting the next buttonhole to be sewn in a sequence
If the sewing menu is shown in the display, you can switch from one
programmed buttonhole to another at any time.
Press the ï or ð cursor key.
–
The next or previous buttonhole shape in the sequence displayed
is selected.
1
25