High-Speed Wheel - Duerkopp Adler 558 Service Instructions Manual

6. High-speed Wheel

10
1
2
3
4
5
6
7
8
9
10
11
After turning the handwheel into the turn-off position (needle high
position) the catches 8 of the high-speed wheel grip in the catches 3 of
the feeding shaft. The changeover from sewing to quick transport is
established.
The setting of the correct clearance between the catches is made with
the gauge (Order no. 558 1636).
Caution Risk of Injury !
Pull the mains plug before setting.
–
Press the coupling lever 6 manually so far back that the
three-armed lever 9 with the square stone 7 is arrested under the
turn-off lever 1.
–
Pull the turn-off lever 1 forward.
The three-armed lever 9 is released.
The roller 4 of the turn-off link 5 lays onto the handwheel.
The turning off of the sewing procedure is initiated.
–
Loosen nut 2 on the reversing lever 10.
–
Set the carrier bush 11 with the high-speed wheel.
The clearance between the catches 8 of the high-speed wheel
and the catches 3 of the feeding shaft should be 1 mm.
Use the gauge to measure the clearance.
–
Turn the handwheel to the turn-off position (needle high position).
The catches grip into one another. The changeover from sewing to
quick transport is established.