Installation And Setup Overview; Physical Connection; Initial Printer Setup - Xerox WorkCentre 7775 User Manual

Installation and Setup

Installation and Setup Overview

Before you can use your printer, you must:
1. Make sure the printer is connected correctly and turned on.
2. Install software drivers and utilities.
3. Configure the software.

Physical Connection

You can connect to your printer over a network. Connect to a functioning and dedicated fax telephone
line for the optional fax. Communication cables are not included with your printer and must be
purchased separately.
Ethernet Network
To physically connect your printer to the network:
1. Connect the power cable to the printer, and plug it into an electrical outlet.
2. Connect one end of a Category 5, or better, Ethernet cable to the Ethernet port in the back of the
printer. Connect the other end of the cable to your network port.
3. If your printer has fax installed, connect to a functioning telephone line using a standard RJ11 cable.
4. Turn the printer on.
Fax Connection
Use a standard RJ11 cable, No. 26 American Wire Gauge (AWG) or larger, to connect your printer to
the telephone line.

Initial Printer Setup

Initial settings must be completed before the printer software can be installed. If the printer has not
been previously powered up and configured, see the System Administrator Guide at
www.xerox.com/office/WC7755_WC7765_WC7775docs.
32 WorkCentre 7755/7765/7775 Multifunction Printer
User Guide