Completing The Parts Replacement - Lenovo ThinkCentre M80 Hardware Maintenance Manual

Figure 34. Securing the socket cover
6. Carefully check the four corners of the socket cover to make sure that the cover is secured in the
microprocessor socket.
7. Lower the microprocessor retainer and then lower the lever to secure the retainer. Make sure the
lever is locked into position.
8. Follow any additional instructions included with the replacement part you received.
Note: If your system board has two microprocessor sockets, be sure to install a socket cover for each
microprocessor socket.

Completing the parts replacement

After completing the installation or replacement for all parts, you need to reinstall the computer cover
and reconnect cables.
To reinstall the computer cover and reconnect cables to your computer, do the following:
1. Make sure that all components have been reassembled correctly and that no tools or loose screws are
left inside your computer. See "Locating components" on page 69 for the locations of the various
components in your computer.
2. If you have removed the front bezel, reinstall it. See "Removing and reinstalling the front bezel" on
page 73.
3. Properly route the cables and keep them clear of the hinges and sides of the computer chassis to
avoid interference with closing the computer cover.
98
ThinkCentre Hardware Maintenance Manual