Completing The Parts Replacement - Lenovo 10KW User Manual

5. Grasp the card that is currently installed and gently pull it out of the slot.
Notes:
• The card fits tightly into the card slot. If necessary, alternate moving each side of the card a small
amount until it is removed from the card slot.
• If the card is held in place by a retaining latch, press the card retaining latch
the latch. Grasp the card and gently pull it out of the slot.
Figure 35. Removing the PCI Express card
6. Remove the new PCI Express card from its static-protective package.
7. Install the new PCI Express card into the appropriate PCI Express card slot on the system board. See
"Parts on the system board" on page 6.
8. Pivot the card latch to the closed position to secure the PCI Express card.
9. Install the screw to secure the card latch.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 66.

Completing the parts replacement

After completing the installation or replacement for all parts, reinstall the computer cover and reconnect
cables. Depending on the parts you installed or replaced, you might need to confirm the updated information
in the Setup Utility program. Refer to "Using the Setup Utility program" on page 29.
To reinstall the computer cover and reconnect cables to your computer, do the following:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside your computer. See "Computer components" on page 5 for the locations of various components
in your computer.
2. Ensure that the cables are routed correctly before reinstalling the computer cover. Keep cables clear of
the hinges and sides of the computer chassis to avoid interference with reinstalling the computer cover.
66
Lenovo S510 User Guide
1 as shown to disengage