Lenovo ThinkCentre M80 Hardware Maintenance Manual page 64

Hardware maintenance manual for thinkcentre m80
Hide thumbs Also See for ThinkCentre M80:
Table of Contents

Advertisement

Diagnostic Error Code
071-00X-XXX 071-01X-XXX 071-02X-XXXAudio port
error
071-03X-XXX Audio port failure
071-04X-XXX Audio port failure
071-195-XXX Audio port Test aborted by user
071-196-XXX Audio port test halt, error threshold
exceeded
071-197-XXX Audio port test warning
071-198-XXX Audio port test aborted
071-199-XXX Audio port test failed, cause unknown
071-25X-XXX Audio port failure
080-000-XXX Game Port interface Test Passed
080-XXX-XXX Game Port interface Error
080-195-XXX Game Port interface Test aborted by user
080-196-XXX Game Port interface test halt, error
threshold exceeded
56
ThinkCentre Hardware Maintenance Manual
FRU/Action
1. Run Setup
2. Flash the system. See "Updating (flashing) the BIOS
from a disc" on page 261.
3. System board
1. Speakers
2. Microphone
3. Audio card, if installed.
4. System board
1. Run Setup
2. Audio card, if installed.
3. System board
Information only Re-start the test, if necessary.
1. Press F3 to review the log file.
2. Re-start the test to reset the log file.
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility program" on page 39.
2. Re-run test
3. Replace the component that is called out in warning
statement.
4. Replace the component under test.
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility program" on page 39.
2. Flash the system and re-test. See "Updating
(flashing) the BIOS from a disc" on page 261.
3. Go to "Undetermined problems" on page 64.
1. See "Undetermined problems" on page 64.
2. Flash the system and re-test. See "Updating
(flashing) the BIOS from a disc" on page 261.
3. Replace component under function test.
1. Speakers
2. Audio card, if installed.
3. System board
No action
1. Remove the game port device and re-test the system.
Information only Re-start the test, if necessary.
1. Press F3 to review the log file.
2. Re-start the test to reset the log file.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents