Xerox WorkCentre 5050 Quick Reference Manual page 101

Options:
Used when you want to send a fax to more than one destination. Enter the number
Add to Send List
using the keypad or select the Phone List button and select a stored number. Then
select the Add to Send List button. Continue to add numbers until all the locations
have been entered.
Stores the list of telephone numbers entered, to enable faxing to multiple locations.
Send List
The number on the Send List button will change, indicating how many telephone
numbers currently reside in the Send List.
Select the Send List button to view or delete telephone numbers.
Dialing characters are special characters used for entering fax numbers and are
Dialing
entered as part of the telephone number:
Characters
Tone Detection [W]
Character Check [+]
Quick Reference Guide
Allows the machine enough time to switch from an inside line
Dial Pause [,]
to an outside line. The delay depends on the fax server.
This pause is used if a longer period is required to gain a dial
Long Pause [I]
tone.
Indicates that an identifier for a previously set up group is
Group Dial [\]
about to be entered.
Used to hide information on printed reports. Characters
Mask Data [/]
entered between two forward slash symbols will appear as
asterisks.
Password Check
Used for remote terminal identification. This character
Switch [S] verifies that the correct number has been dialed.
Pulse-To-Tone Use to switch from Pulse dialing to Tone dialing.
Switch [:]
Wait for Network Use to suspend dialing until an expected network tone is
detected.
Local ID [+] Required as part of some international telephone numbers (in
place of 00).
Page 5-25