Activating The Next Seam Sequence When The Thread Is Cut; Rotation In The Reference Position - Duerkopp Adler 275 Instruction Manual

8.1.3 Activating the next seam sequence when the thread is cut

When the program contains fullnesses the next seam sequence
is normally activated by the thread cut. There are three options
when the thread is cut. The procedure for selecting them is as
follows:
–
–
–
The machine is factory-set to "02".

8.2 Rotation in the reference position

Every time the machine is switched on the step motor that sets the overfeed length
rotates to the reference position, then back to the current overfeed length. This is
necessary for the display to coincide with the overfeed length.
The procedure for checking this function is as follows:
–
swivel the machine back
–
switch it on
–
after the internal system check the step motor rotates to the reference position
–
the LED in the inductive key briefly lights up when the reference position has been
reached
–
the motor then rotates to the current overfeed-length position.
50
After calling special functions (see section 8.1)
press the 5 key.
The function can now be switched with the +/- keys:
display 00 = the next sequence is not activated
when the thread is cut.
display 01 = the next sequence is activated after each thread
cut.
display 02 = as 01, but when change-of-direction is switched
on the direction is changed in the first and last sequence by
the first thread cut and the next sequence activated by the
second thread cut.
Press the "F" key twice to save the setting and terminate
the function.
Caution: danger of injury
When checking the reference position take care to avoid
moving parts.