Changing Technician-Level And Manufacturer-Level Parameter Values With The V820 Operating Panel - Duerkopp Adler 275 Instruction Manual

7.3.7 Changing technician-level and manufacturer-level parameter values with
the V820 operating panel
Entering the technician-level code
–
Turn off the main switch.
–
All plugs on the sewing-drive control must be plugged in.
–
Press and hold down the "P" key.
–
Turn on the main switch: "C-0000" appears in the display.
–
Release the "P" key.
–
Enter code 1907 with number keys 0 to 9.
–
Press the "E" key: the first technician-level parameter, "F-100", is displayed.
Selecting parameters and changing values
–
After the code is entered the first parameter, "F-100", is displayed.
–
Enter the required parameter number with number keys 0 to 9.
–
Press the "E" key: the value of the selected parameter is displayed.
–
Press the "+" or "-" keys to change the value of the parameter.
–
Press the "E" key to display the next parameter
or the "P" key to display the same parameter.
Saving changed parameter values
–
Press the "P" key to end programming.
–
Sew a complete seam, i.e. push the pedal forwards and then fully back. The
change is saved.
–
If no seam is sewn, the change is lost.
–
Press the "P" key again to return to the programming level.
Entering the manufacturer-level code
–
Turn off the main switch.
–
Press and hold down the "P" key.
–
Turn on the main switch: "C-0000" appears in the display.
–
Release the "P" key.
–
Enter code 3112 with number keys 0 to 9.
–
Press the "E" key: the first manufacturer-level parameter, "F-200", is displayed.
–
Continue as described under section 7.3.7, "Selecting parameters
and changing values".
CAUTION:
The changed parameter values are not saved unless a
complete seam is sewn after leaving the programming
level, i.e. the pedal is pushed forwards and then
all the way back.
If the drive is switched off straight after leaving the
programming level, the changes are lost.
GB
45