Main Level Of The Menu System; Direct Editing Of The Values In The Main Level; Selecting The Buttonhole Program - Duerkopp Adler 559 Operating Instructions Manual

10.3 Main level of the menu system

1 2

10.3.1 Direct editing of the values in the main level

10.3.2 Selecting the buttonhole program

After the automat has been switched on and while sewing the display
of the automat indicates the main level of the menu system. In the main
level three values are indicated:
- The buttonhole program 1
- The needle thread tension 2 (in the example 43)
- The cutting length 3 (in the example 20)
3
In the main level there are the following options:
- Direct editing of the values in the main level ("F"-key)
- Buttonhole programming ("P"-key)
- Sewing start (control panel, push button, pedal)
The values of the main level can directly be altered as follows:
"F"-key Press the "F"-key in order to edit the values of the
main level. A value of the main level is blinking.
Keys ïð
Change over to the value you want to alter with
the keys ïð. The selected value is blinking.
Keys ñò Change the selected value with the keys ñò.
With the key ñ you increase the value, with the
key ò you reduce it. If you have altered a value,
you can no longer change over to another value
with the keys ïð.
"OK"-key Take over the set value with the "OK"-key.
You quit the editing mode. The values of the main
level are indicated.
"ESC"-key Cancel the alteration with the "ESC"-key.
The altered value is not taken over.
You quit the editing mode. The values of
the main level are indicated.
In the main level you can directly select a buttonhole programmed
before:
"F"-key Press the "F"-key. A value is blinking
in the display.
Keys ïð Select the left field with the keys ïð.
The buttonhole program (P01 to P05) is blinking.
Keys ñò
Select the desired buttonhole program with the
keys ñò.
"ESC"-key Press the "ESC"-key in order to cancel
alterations.
"OK"-key Press the "OK"-key for confirmation.
(in the example P02)
1
21