Changing Parameter Values - Duerkopp Adler 467 Operating Instructions Manual

6.3 Changing parameter values

At the operator level parameter values are changed with the four green keys ("P", "E",
"+", "-") beneath the display.
The parameter list on the next page lists all the parameters which can be changed from
operator level.
1. Start programming mode
-
Press "P" key.
The LED above the key flashes.
This indicates that the control unit is in programming mode.
2. Display first operator-level parameter
-
Press "E" key.
The first parameter appears in the display with the corresponding parameter va-
lue.
Example: "Arv 250"
3. Change displayed parameter value
-
Increase or reduce the parameter value with den "+" and "-" keys.
If the "+" or-" key is held down, the parameter value continues to rise or fall until it
is released.
4. Save changed parameter value
-
Press "E" key.
The changed parameter value is saved.
-
The next operator-level parameter appears in the display.
Repeatedly pressing the "E" key successively calls up all operator-level parame-
ters.
5. Leaving programming mode
-
Press "P" key.
The last parameter value to have been changed is saved.
-
The control unit leaves programming mode.
Arv = abbreviated parameter designation
250 = parameter value set
19