Dometic RM24A Service Manual page 25

Remove the connection block cover on the side of the boiler case and disconnect
7,
two electrical wires where they join the heater leads in the connection
the
block.
Remove the grounding screws "A" (see Fig. 46) on the lower part of the boiler
8.
case.
Remove the flue and the flue baffle.
9.
Remove the screws "B" (see Fig.
10.
the cabinet.
Release the piezo electrode.
11.
Carefully slide absorption unit out of cabinet. Be careful not to damage the
12.
inner liner of the cabinet,
To replace absorption unit, reverse above procedure.
13.
CAUTION :
Be sure to apply sealing permagum "A" (fig. 44 and fig. 45) on the unit mounting
1.
plate and on the high evaporator inlet tube (B).
Be sure to fit insulation pad (C) and sealing (D) (only on RM36C).
2.
3. Be sure to apply proper amount of "Thermal Mastic" on the evaporator coil "E"
( fig. 44 a n d fi g . 45).
When fitting the evaporator flange(s) be sure to tighten the screws properly in
4.
order to obtain a perfect contact between the evaporator coil and evaporator
flange, otherwise improper cabinet performance may result.
RM36C
Fig. 44
46) holding the absorption unit onto the back of
RM46, RM47
RM66, RM67
Fig. 1 5
25