Dometic RM 2355 Installation And Operating Instructions Manual

Dometic RM 2355 Installation And Operating Instructions Manual

Refrigerator for lp-gas and electric operation

Advertisement

REFRIGERATOR FOR LP-GAS AND ELECTRIC OPERATION
RA/RM-1D
RA/RM-2D
FOR YOUR SAFETY
If you smell gas:
1. Open windows and door.
2. Don't touch electrical switches.
3. Extinguish any open fl ame.
4. Immediately call your gas supplier.
FOR YOUR SAFETY
Do not store or use gasoline or other
fl ammable vapors and liquids in the
vicinity of this or any other appliance.
WARNING
Improper installation, adjustment, altera-
tion, service or maintenance can cause
injury or property damage. Refer to this
manual. For assistance or additional infor-
mation consult a qualifi ed installer, serv-
ice agency or the gas
supplier.
825 12 40-02
INSTALLATION AND

OPERATING INSTRUCTIONS

AES III
RM 2355
RM 2455
RM 2555
RM 4605

Advertisement

Table of Contents
loading

Summary of Contents for Dometic RM 2355

  • Page 1: Operating Instructions

    INSTALLATION AND OPERATING INSTRUCTIONS REFRIGERATOR FOR LP-GAS AND ELECTRIC OPERATION RA/RM-1D RA/RM-2D AES III RM 2355 FOR YOUR SAFETY If you smell gas: 1. Open windows and door. 2. Don’t touch electrical switches. 3. Extinguish any open fl ame. 4. Immediately call your gas supplier. RM 2455 RM 2555 FOR YOUR SAFETY...
  • Page 3: Table Of Contents

    OPERATING AND INSTALLATION INSTRUCTIONS FOR RM 2355, RM 2455, RM 2555 & RM 4605 INTRODUCTION CONTENTS We are pleased that you have chosen this refrigerator and hope OPERATING INSTRUCTIONS _______________________ 4 you will derive much satisfaction from using it. CONTROL PANEL ........4 The refrigerator is designed for installation in motorhomes and intended for storage of foods, frozen foods and making ice.
  • Page 4: Operating Instructions

    In case the appliance fails to operate correctly, contact an au- Press the ON/OFF button (1). The refrigerator starts in the thorised Dometic Service Centre. mode it was in when it was turned off. Press the AES/GAS button (2) and LED (A) or (B) comes 230-240V OPERATION on.
  • Page 5: Switching Between Energy Sources

    SWITCHING BETWEEN ENERGY SOURCES DEFROSTING When switching from one energy source to another, there are Frost will gradually accumulate on the refrigerating surfaces. some delays implemented in the AES system. The 15 min. Each time the door is opened some of the cold air in the refrig- delay between switching off the engine and starting gas mode erator spills out and is replaced by warm moist room air.
  • Page 6: Cleaning The Refrigerator

    CLEANING THE REFRIGERATOR PRODUCT CARE - SOME USEFUL HINTS Clean the inside of the refrigerator regularly to keep it fresh Make sure that: and hygienic. Defrosting is carried out periodically. • The refrigerator is clean and dry with the door left open •...
  • Page 7: Maintenance

    The flue gases are dispersed from the ventilation passage using • Ensure that the gas safety shut-off valve is working properly. the Dometic flueing system. The top, bottom and sides of the • Make sure that the ventilation openings are unobstructed.
  • Page 8 CLEARANCES Minimum clearances (mm) to combustible materials are: RM 2355 RM 2455 - RM 2555 - RM 4605 (Fig. 5 & (Fig. 5 & Fig. 6) Fig. 7) Side Bottom Rear Fig. 5 The distance between the rearmost part of the refrigerator and the wall behind the refrigerator.
  • Page 9: Connecting Points

    CONNECTING POINTS Dimensions to connecting points (mm). RM 2355 Electrical connection connection point point Flue outlet pressure test Electrical point connection connection point point RM 2455 Electrical connection connection point point Flue outlet pressure test point connection point Electrical connection point...
  • Page 10 RM 2555 Electrical connection connection point point Flue outlet pressure test point Electrical connection connection point point RM 4605 Electrical connection connection point point Flue outlet pressure test point Electrical connection point connection point...
  • Page 11: Installation/Building-In

    INSTALLATION/BUILDING-IN SECURING THE REFRIGERATOR The refrigerator must not be exposed to radiated heat from hot For the best cooling performance, when installing the refrigera- objects. Excessive heat irradiation impairs performance and tor model(s): leads to increased energy consumption. For this reason the re- •...
  • Page 12: Drain Water Hose

    DRAIN WATER HOSE Once the lower front strip is slipped under the hinge, the part is possible to A hole must be drilled swing into place as shown in Fig. 13. through flooring see Fig. 16 / 17. The installer has to make sure that the hose does not kink when run through the floor.
  • Page 13: Mounting Instructions

    ELECTRICAL CONNECTION CROSS-SECTIONS The electrical installation must be carried out by authorised The D+ (alternator) is a signal cable and therefore 1-1.5 mm personnel. is sufficient. Connection to 12V + and - must be done with a 10 mm wire if the total wire length (+ and - wire together) is NOTE! For mains voltage operation, it is important that maximum 12 m.
  • Page 14 With screws (see Fig. 20 and Fig. 22) With screws Snap in To mount the door panel, follow these steps: Open the door 90 degrees. On new refrigerators, the decoration strip is taped inside the door; if installed on the door, remove the door decoration strip (2) by removing its three screws (1).
  • Page 15: Positioning Of Shelves

    POSITIONING OF SHELVES ����� ��� ���� ����� �� ��� ����� ��� ���������� ���� �� ��� ����� ���� ���� ������ ������ ��� ���� �� ��� ���� ����� �� ��� ��� ��� ��� ��������� ���� ����� ��� �� ��� ����� ��������� ���� �� ��� ������� ��������� �����...
  • Page 16: Technical Data

    TECHNICAL DATA RM 2355 RM 2455 RM 2555 RM 4605 Overall dimensions Height (mm) 1104 1385 Width (mm) Depth incl. cooling unit (mm) Recess dimensions Height (mm) 1083 1365 Width (mm) Depth (mm) Capacity Gross (litres) Weight without packaging (kg) 44,5 56,5 Electrical data (watt)
  • Page 17: Rearview Equipment

    REARVIEW EQUIPMENT RM 2355 Heaters Flue baffle Reigniter Relay Drain water hose Power module cover (PC board) Protection cover Inlet fitting Screw for protection cover Burner jet Terminal block 12V DC only Manual gas shutoff valve Flexible cord 12 or 24V DC RM 2455 - RM 2555 Heaters Relay...
  • Page 18: Wiring Diagram

    WIRING DIAGRAM RM 2355 - RM 2455 - RM 2555 RM 4605...
  • Page 19: Working Instructions For The Gas Safety System

    WORKING INSTRUCTIONS FOR THE GAS SAFETY SYSTEM WORKING DIAGRAM Thermostat Spark Gas valve Flame detector device Lock out indication TW TS TS TWI TS TWI TS TECHNICAL SPECIFICATIONS Classification codes according to EN298 A-M-R-V-X-K Class of protection according to Low Voltage Directive IP-20 Waiting time / TW Safety time / TS...
  • Page 20: Appendix A - Airing Position Card

    APPENDIX A - AIRING POSITION CARD Use the Airing Position Card to keep the doors ajar if the refrigerator will not be in use for an extended period of time or put in storage. RM 2455 AND RM 2555...
  • Page 21 APPENDIX A - AIRING POSITION CARD RM 4605...
  • Page 22 NOTES...
  • Page 24 MO-M 0552...

This manual is also suitable for:

Rm 2555Rm 4605Rm 2455Rm 2555Rm 4605

Table of Contents