Dometic RM24A Service Manual page 46

46
The Piezo lighter does not normally need any maintenance.
If by any reason the electrode or the lighter must be replaced, proceed as follows:
Replacement of electrode only.
Unscrew burner outer shield.
1.
2.
burner housing.
3. Loosen the electrode from its cable by unscrewing the electrode anti-clockwise.
4. Pit a new electrode,
When fastening the electrode on the burner housing make sure that the
CAUTION :
insulation plate is properly fitted between the burner housing and
t h e e l e c t r o d e ( s e e f i g . 7 8 ) .
Replacement of Piezo lighter complete
1. Release the Piezo lighter knob "E" (see fig. 72)
pulling the knob outwards.
Loosen outer burner shield and burner housing.
2.
Loosen the fastening screw "A" (Fig. 78) h o l d i n g
3.
burner housing.
4. Loosen the two
screws
pulled out at the rear of the cabinet.
5. To fit new lighter, reverse above procedure.
inside the cabinet by means of
the electrode against side of
lighter complete can be
Electrode
Fig. 7R