Replacing Accessory Boards - HP Tc2110 - Server - 128 MB RAM Maintenance Manual

Chapter 7
2. Disconnect the power cord and any external cables connected to the Server.
If necessary, label each one to expedite re-assembly.
3. Remove the left side cover.
WARNING The power supply will continue to provide standby current to the HP Server tc2110 until
the power cord is disconnected from the AC power source.
CAUTION Wear a wrist-strap and use a static-dissipating work surface connected to the chassis
when handling components. Ensure the metal of the wrist-strap contacts your skin.
4. Lay the Server on its side with the system board facing up (component side up).
5. Remove any cables attached to the accessory board.
If necessary, label each one to expedite re-assembly of a replacement board.
6. Remove the slot cover latch by:
a. Lift up on the tab of slot cover latch.
b. Raise the slot cover latch up from the slot covers.
c. Remove it from the chassis and keep it for reassembly.
You may need to lift the slot cover latch out of its retainer before lifting it out of the chassis.
7. Lift the accessory board up and away from the slot.
8. Place the accessory board and any cables in an anti-static container.

Replacing Accessory Boards

1. Read the documentation included with the accessory board and follow any special instructions.
2. If your installing the accessory board into a new PCI slot, continue with Step 3.
If the accessory board is a replacement for a defective board, skip to Step 5.
88
Figure 7-14. Removing Slot Cover Latch
Replacing Parts