HP Tc2110 - Server - 128 MB RAM Maintenance Manual page 95

Chapter 7
3. Remove the slot cover latch by:
a. Lifting up on the tab of slot cover latch with your finger.
b. Raise the slot cover latch up away from the slot covers.
c. Remove it from the chassis and keep it for reassembly later.
You may need to lift the slot cover latch out of its retainer before lifting it out of the chassis to
remove the slot cover latch.
4. Select the desired accessory slot cover, slide the top of the slot cover away from the chassis, and then lift
it up and out of the chassis as shown in the following illustration.
5. Slide the accessory board into the desired PCI slot and then press down to seat the board.
6. Ensure the accessory board is seated properly in the PCI slot.
7. Replace the slot cover latch to ensure the accessory board is held in place.
Slot Cover
Figure 7-15. Removing the Slot Cover
Figure 7-16. Inserting an Accessory Board
Replacing Parts
89