Replacing The Flexible Disk Drive; Removing The Cd-Rom - HP Tc2110 - Server - 128 MB RAM Maintenance Manual

Chapter 7
7. Remove the flexible disk drive from the tray.
8. Place the flexible disk drive in an anti-static bag.

Replacing the Flexible Disk Drive

1. If not already mounted, insert the new drive in the tray (pin side first), and then replace the side screws.
2. With the cable connectors toward the rear of the chassis, slide the FDD assembly all the way into the
chassis, until the FDD assembly snaps into place.
The flexible disk drive is only mounted in the top shelf (shelf 1).
3. At the rear of the flexible disk drive, carefully connect the power and data cable.
4. Replace the upper bezel.
5. Replace the left side cover.
6. Replace the external cables and power cord.
7. Power on the Server as described in Chapter 1, "Controls and Indicators."

Removing the CD-ROM

16. If the Server is operating, power down the Server.
Refer to Chapter 1, "Controls and Indicators" for instructions.
17. Disconnect the power cord and any external cables connected to the Server.
If necessary, label each one to expedite re-assembly.
18. Remove the left side cover.
Refer to "Opening and Closing the HP Server" in Chapter 3.
19. Remove the upper bezel.
Refer to "Opening and Closing the HP Server" in Chapter 3.
20. At the rear of the CD-ROM, carefully disconnect the power and data cables.
21. Remove the CD-ROM:
Press in on both release tabs to release the CD-ROM tray assembly.
Figure 7-2. Removing the Flexible Disk Drive (FDD)
Replacing Parts
75