Directed Electronics AutoCommand 41027T Owner's Installation Manual page 40

Programming System Settings
Many of the features and operations of this system can be
changed to suit most of today's vehicle electrical systems. The
programming routine and feature menus that follow will allow
making the changes required for most vehicle installations.
System programming routine:
Accessing a Menu:
1. Turn the ignition ON and then OFF in less than 5 seconds
2. Within 3 seconds Press/Hold the Momentary Switch
3. After 2 seconds the LED will flash and the Horn/Siren
will pulse to indicate the available menus. It will toggle
through the outputs until a menu is chosen.
a. Menu 1: 1 LED flash and Horn/Siren pulse
b. Menu 2: 2 LED flashes and Horn/Siren pulses
4. Release the Momentary Switch after the appropriate
output to access that Menu. The LED and Horn/Siren
outputs will cease.
Accessing a Feature Location:
1. Press and release (do not hold) the Momentary Switch
the same number of times as the feature location to be
accessed. See the Feature Chart for locations.
2. After 2 seconds the LED will flash (the number of flashes
will match with the feature location) to confirm the
feature location. It will flash/pause and repeat until the
feature is changed or programming is exited.
3. Press a button on the transmitter to change the feature
© 2006 Directed Electronics
37