Directed Electronics AutoCommand 41027T Owner's Installation Manual page 21

Many Nissan and late-model Chrysler vehicles have two starter
wires. A relay and/or resistor (not provided) is required to hook up
the additional starter wire. Refer to the diagram below.
YELLOW (+) OUTPUT
TO STARTER
note! Always check the Web site information
on your vehicle for warnings regarding the
starter wire and check engine lights. Some
vehicles will trip a check engine light if the
starter wire is cut.
Once you locate the starter wire, cut the wire in half (check the
web information before cutting) and try to start the vehicle. If
the vehicle does not start, the correct wire has been identified.
Reconnect both ends of the starter wire while soldering the thick
YELLOW (6) wire of the heavy guage wires to it and wrap the
connection with electrical tape.
18
+12 VDC CONSTANT (FUSED 20A)
TO STARTER
+12 VDC CONSTANT (FUSED 20A)
STARTER RELAY
(NOT PROVIDED)
87
GROUND
86 85
87A
30
TO STARTER
2 nd STARTER RELAY
(NOT PROVIDED)
87
GROUND
86 87A 85
30
TO 2 nd STARTER
© 2006 Directed Electronics