Installation Overview; Step 1, Heavy Gauge Wire Connections - Directed Electronics AutoCommand 41027T Owner's Installation Manual

Installation Overview

Be sure to read this section thoroughly in its entirety before start-
ing the installation. Pay special attention to all warnings to pre-
vent personal injury or damage to your vehicle.
Visit our 24-hour technical web site (www.autocommand.com) to
get a vehicle-specific wiring guide prior to starting this installa-
tion.
Have your crash code number handy when contacting tech support
or visiting the web site. During the installation if you are unable
to find answers to your questions on the web site, call 1-800-477-
1382 for live technical assistance. Please note that live technical
support is available Monday-Friday 6am-6pm PST, and Saturday-
Sunday 7am-3:30pm PST.
WARNING!
➤
Verify that the transmission is set to park and that
the parking brake is set before beginning installation.
➤
On vehicles with air bags or supplemental restraint
systems (SRS) you may notice a bright yellow tube
with small wires in it marked SRS underneath the
steering column near the key cylinder. DO NOT tamper
or unplug these for any reason to prevent costly dam-
ages to your vehicle or personal injury. Tampering
may cause unintended deployment of airbags.
➤
This system is intended for automatic, fuel-injected
vehicles only. Installation in any other vehicle is con-
trary to its intended use.
Step 1,
Heavy Gauge Wire Connections
© 2006 Directed Electronics
11