Step 7, Programming - Directed Electronics AutoCommand 41027T Owner's Installation Manual

Step 7, Programming

Programming transmitters
Your system can learn up to 4 transmitters. The following proce-
dure will show you how to add additional transmitters or replace
old ones. Each transmitters can be programmed one button at a
time or you can use an auto learn procedure that learns the
intended factory configuration. Learning one button at a time is
generally only used when using one transmitters to control two
different cars. Being able to program functions to different chan-
nels on each transmitters prevents multiple cars from responding
simultaneously.
1. Turn the ignition ON
2. Press/release the momentary switch the same number of
times as the desired transmitter learn Step number, and
then Press/HOLD.
3. After Holding the momentary switch for 2 seconds the
LED will begin to flash to indicate of the accessed trans-
mitter learn Step.
4. Press the transmitter button that you want to control
the function assigned to that transmitter learns Step;
the Horn/Siren will emit a long chirp.
note! For transmitter learn Step #1, you must press
the "*" button on the transmitter, this will auto-
matically program the transmitter buttons to the
default function configuration. See the transmit-
ter button auto learn chart for the assignment
functions.
34
© 2006 Directed Electronics