Service Test Print - Canon BJC-1000 Service Manual
Hide thumbs
Also See for BJC-1000:
- Setup instructions (4 pages) ,
- User manual (112 pages) ,
- Specification (2 pages)
Table of Contents
Advertisement
Part 3: Operating Instructions
2.3.2 Service test print
On the service test print, the control ROM version, and EEPROM (IC8) data are
printed, as shown below.
ROM Ver X.XX
BC-02
The service test print is produced in the following procedure:
1. Without a cartridge installed, connect the plug of the AC adapter to the AC outlet
while holding down the RESUME button.
2. Release the RESUME button. Press it down again within five seconds and release it.
The carriage moves to the center, and stops.
3. Open the front cover and install the black BJ cartridge.
4. Close the front cover and press the RESUME button twice. The printer starts the
service test printing.
Total Number of Pages Passed When Using Cartridge
LostInk XX.X% PageCount->
BK XXXXX
Total Waste Ink Amount (absorption ratio of the waste ink absorber: %)
Version Number of Control ROM
Figure 3-14 Service Test Print
3-12
CL XXXXX
LD XXXXX
BJC-1000
Photo
Color
Black
Advertisement
Table of Contents
