Table of Contents
Advertisement
Part 3: Operating Instructions
2.3.2 Service test print
On the service test print, the control ROM version, and EEPROM (IC1) data are
printed, as shown below.
ROM Ver X.XX
BC-20
CG-ROM Ver X.XX
The service test print is produced in the following procedure:
1. Without a cartridge installed, connect the plug of the AC adapter to the AC outlet
while holding down the RESET button.
2. Release the RESET button. Press it down again within five seconds and release it.
3. Open the front cover and install the black BJ cartridge.
4. Press the RESET button twice and close the front cover. The printer starts the
service test printing.
Total Number of Pages Passed When Using Cartridge
LostInk XX.X% PageCount-> BK XXXXX PB XXXXX CL XXXXX VC XXXXX LD XXXXX VL XXXXX SC XXXXX
BJC-2000
Wiping XXXXXXK ManualPurge XXXXX DryTime : OFF PurgeFlag : 3Fh Door : CLOSE
Total Waste Ink Amount (absorption ratio of the waste ink absorber: %)
Version Number of Control ROM
Version Number of CG
Figure 3-19 Service Test Print
3-18
BJC-2000
Scanner
Photo
Color
Black
Advertisement
Table of Contents
