Table of Contents
Advertisement
One of the following feature codes (FC) must be ordered along with the system:
FC 7998 IBM Rack-mount Drawer Bezel
FC 7999 OEM Rack-mount Drawer Bezel and Hardware
The OpenPower 710 server can be installed in either IBM or OEM racks. There is only one
adjustable rack-mount drawer rail kit available for both IBM and OEM racks:
FC 7166 IBM/OEM Rack-mount Drawer Rail Kit
It is possible to place up to 21 systems in an area of 644 mm (25.5 inches) x 1147 mm (45.2
inches) if one 42U-high rack is used. The 14 ft. length of the jumper cords (between the
drawer and the PDU) will require additional cable management. The extra length of a cord not
used in its routing between its two ends will have to be accounted for inside rack space.
Included with the OpenPower 710 rack-mounted server packaging are all of the components
and instructions necessary to enable installation in a 19-inch rack.
Figure 1-2 shows a more detailed view of the OpenPower 710 rack-mount server, including
connectors, location codes, SCSI IDs, and components.
Figure 1-2 Front and rear view of the OpenPower 710 server including location codes
Chapter 1. General description
3
Advertisement
Table of Contents
