Table of Contents
Advertisement
1
2
3
4
5
OPERATION GUIDE
Originals to Avoid
Be sure not to use the following originals in the document processor.
•
Originals with punched holes or perforations.
•
Transparencies.
•
Soft originals such as carbon or vinyl paper, or other originals that are curled,
wrinkled or creased.
•
Irregularly shaped originals, wet originals, or originals that have adhesive tape
or glue on them.
•
Originals with clips or staples. Remove the clips or staples, and straighten any
curls, wrinkles or creases, before placing them in the document processor.
Failure to do so may result in the originals being jammed.
•
Originals with cut-out sections or that have a slippery surface on either side.
•
Originals on which any correction fluid is still wet.
•
Folded originals - smooth out the folds before setting them in the document
processor. Failure to do so may result in the originals being jammed.
Check that there are no other originals remaining in the document processor.
Be sure to fan through the originals a few times to separate the sheets before placing
them in the document processor.
Adjust the original insert guides to fit the
width of original to be copied.
Pull the ejection extension when using A4.
Arrange the originals in order and place
them face up on the original table. Slide the
leading edge of the originals securely into
the document processor as far as they will
go.
Copy Functions
4-3
Advertisement
Table of Contents
