Table of Contents
Advertisement
Setup
Setup
There are a variety of parameters that can be set to configure the printer to specific requirements in the
"Setup" menu of the Offline Menu.
The setup should be performed when operating the printer for the first time and also when basic changes
need to be carried out. In most cases however, simple changes such as heat setting adjustments, using
different media will be made with software settings.
The "Setup" menu can be protected from unauthorized access by using a code number (PIN).
1.
Switch to the Offline Menu by pressing the
2.
Continue to press the
3.
If the "Setup" menu is protected by a PIN the display will show "PIN: 0000". You will need to enter
the correct PIN before you can continue. The numbers of the PIN can be changed by using the
key and the
move to the next number. If the correct number is entered, the "Setup" menu is displayed.
4.
The parameters are arranged in a tree like structure. Pressing the
scroll between the secondary menus. By pressing the
chosen.
5.
If a parameter is selected, the display shows the actual value underneath the parameter. On the
top line the symbol
parameter choices by pressing the
6.
To change the current setting press the
display and it indicates that it is possible to change the setting of the parameter by pressing the
key and the
7.
Press the
symbol
8.
Press the
Ready
Setup
The parameters marked with [...] are only accessible, if an optional device has been installed.
Table 2 Structure of the "Setup" menu under the Offline menu
20
key and the
key. The position to be changed will be flashing on the display. Press the
is shown. This symbol indicates that it is possible to switch between the
key.
key to confirm the change. To cancel the change press the
appears on the top line again.
key several times if necessary to return to the "Setup" menu or to "Ready" mode.
Local settings
Machine parameters
Print parameters
Interfaces
Security
key.
key until you reach the "Setup" menu. Press the
key, the selected secondary menu will be
key and the
key.
key. Then the symbol
Country
Timezone
Daylight saving
Set date
Set time
Printhead pos. X
Printhead pos. Y
Applicator
Brightness LCD
Contrast LCD
Time Powersave
Debug mode
Heat level
Print speed
Transfer print
Warn level ribbon
Label sensor
Pause-Reprint
Error-Reprint
Barcode error
Width ASCII dump
Character set
IEEE 1284
RS-232
[RS-422/485]
[Ethernet]
[Keyboard]
PIN
Printer Applicator System PAM 3600
key.
key to
key as well as the
key will
is shown in the lower line of the
key. In both cases the
Advertisement
Table of Contents
