Table of Contents
Advertisement
RDS Operation
INTLZ
TUNE
Setting RDS Reception Mode and
Receiving RDS Stations
The RDS (Radio Data System) is a radio
information system using the 57 kHz subcarrier of
regular FM broadcast. The RDS allows you to
receive a variety of information such as traffic
information, station names, and to automatically
re-tune to a stronger transmitter that is
broadcasting the same programme.
1
Press the F button so that the FUNC indicator
will illuminate.
2
Press the F1 (AF) button to activate the RDS
mode.
3
Press the DN g or f UP button to tune in
the desired RDS station.
NOTE
When the BAND button is pressed and held for more than
2 seconds while a station name is displayed, the display
shows the station frequency for 5 seconds.
When the RDS station signal received has
become weak:
AF seek mode, press and hold the F1 (AF)
button for at least 2 seconds to have the unit
automatically seek a stronger station in the AF
list.
If there is no AF station, the display shows
"SEEK END."
4
Press the F1 button again to deactivate the RDS
mode.
5
Press the F button to activate the normal mode.
The FUNC indicator will turn off.
14
-EN
f UP F F1 F2 F3
DN g
Tips
The RDS digital data includes the followings:
PI
Programme Identification
PS
Programme Service Name
AF
List of Alternative Frequecncies
TP
Traffic Programme
TA
Traffic Announcement
PTY
Programme Type
EON
Enhanced Other Networks
R.TEXT Radio Text Information
Recalling Preset RDS Stations
1
Press the F button so that the FUNC indicator
will illuminate.
2
Press the F1 (AF) button to activate the RDS
mode.
The display shows "AF" when the RDS mode is
activated.
3
Press the F button to activate the normal mode.
The FUNC indicator will turn off.
4
Make sure that the FUNC indicator light goes
out, then press the F1 through F6 buttons in
which your desired RDS station is preset.
If the preset station's signal is weak, the unit
automatically searches and tunes to a stronger
station in the AF (Alternative Frequencies) list.
5
If the preset station and the stations in the AF list
cannot be received:
The unit searches again for a station in the PI
(Programme Identification) list.
If there are still no stations receivable in the area,
the unit displays the frequency of the preset
station and the preset indicator disappears.
If the signal level of the Regional (Local) station
being tuned becomes too weak to receive, press
the same F1 through F6 buttons to tune in a
Regional station in other district.
NOTE
For presetting the RDS stations, refer to the Radio
Operation section. The RDS stations can be preset in the
FM1, FM2 and FM3 bands only.
Advertisement
Table of Contents
