Equalizer Presets; Adjusting The Equalizer Settings; Memorizing The Equalizer Settings; Recalling The Memorized Equalizer - Alpine CDA-7969R Owner's Manual

Basic Operation
Digital Time Correction

Equalizer Presets

Six typical equalizer settings are preset at the
factory for a variety of musical source material.
1
Press the 7-Band Graphic EQ button to switch
to the EQ mode.
2
Press the Preset buttons (F1 through F6)
within 10 seconds to select the desired mode.
F1: FLAT
Flat frequency
F2: MALE (VOCAL)
Suppress higher frequencies
F3: FEMA (VOCAL)
Emphasize midrange
F4: POPS
Suppress midrange
F5: ROCK
Emphasize lows and highs
F6: NEWS
Boost midrange and suppress highs and lows

Adjusting the Equalizer Settings

You can modify the Equalizer settings to create a
response curve more appealing to your personal
taste.
1
Select the equalizer characteristic to adjust.
See Equalizer Presets (see this page).
2
Press and hold the 7-Band Graphic EQ button
for at least 2 seconds within 10 seconds of step 1.
3
Press either the F1 or F2 button within 10
seconds of step 2, to select the frequency band
to adjust.
→ 63Hz ←→ 160Hz ←→ 400Hz ←→ 1kHz ←
→ 16kHz ←→ 6.3kHz ←→ 2.5kHz ←
10
-EN
7-Band Graphic EQ
DN g f UP F F1 F2
Preset buttons (F1 through F6)
4
While the FUNC (Function) indicators is flashing,
press either the DN g button or the f UP
button to adjust to the desired level.
To adjust another frequency band, repeat the
above procedure.
NOTE
All band levels will become flat when the F6 button is
pressed.

Memorizing the Equalizer Settings

1
Recalls the manufacturer's settings of the
equalizer. In addition, allows you to store your
own sound preferences for later recall. (see this
page)
2
Press the F button within 10 seconds of step 1.
3
Within 10 seconds after operating step 2, press
and hold any one of the Preset buttons (F1
through F6) for at least 2 seconds.
4
Repeat steps 1 to 3 to store other settings.

Recalling the Memorized Equalizer

1
Press 7-Band Graphic EQ button to switch to
the EQ mode.
2
Press the F button.
3
To recall your preset, pressing one of the Preset
buttons (F1 through F6) within 10 seconds
after the operation in Section 2. This provides
sound characteristics of your own design.