Card Overview - Cisco ONS 15454 DWDM Reference Manual

Common Control Cards
The terms "Unidirectional Path Switched Ring" and "UPSR" may appear in Cisco literature. These terms
Note
do not refer to using Cisco ONS 15xxx products in a unidirectional path switched ring configuration.
Rather, these terms, as well as "Path Protected Mesh Network" and "PPMN," refer generally to Cisco's
path protection feature, which may be used in any topological network configuration. Cisco does not
recommend using its path protection feature in any particular topological network configuration.
This chapter describes the Cisco ONS 15454 common-control cards. For installation and card turn-up
procedures, refer to the Cisco ONS 15454 DWDM Procedure Guide. For card safety and compliance
information, refer to the Cisco Optical Transport Products Safety and Compliance Information
document.
Unless otherwise specified, "ONS 15454" refers to both ANSI and ETSI shelf assemblies.
Note
Chapter topics include:
•
•
•
•
•
•

2.1 Card Overview

The card overview section lists the cards described in this chapter.
Each card is marked with a symbol that corresponds to a slot (or slots) on the ONS 15454 shelf assembly.
The cards are then installed into slots displaying the same symbols. See the
Requirements" section on page 1-61
78-18343-02
2.1 Card Overview, page 2-1
2.2 TCC2 Card, page 2-2
2.3 TCC2P Card, page 2-6
2.4 AIC-I Card, page 2-10
2.5 MS-ISC-100T Card, page 2-15
2.6 Front Mount Electrical Connections, page 2-18
C H A P T E R
for a list of slots and symbols.
Cisco ONS 15454 DWDM Reference Manual, R8.5
2
"1.16.1 Card Slot
2-1