Displaying The Sirius Id (Esn); Initialization Of Id Code; Master Code Input Preparation; Master Code Input Determination - Mazda CX-7 Owner's Manual

CX-7_8CG3-EA-11J_Edition1 Page277
Saturday, September 24 2011 10:33 AM
When the seek tuning button (
pressed (about 1.5 seconds), playback
starts from the beginning of the next
program. When the seek tuning button
( ) is pressed (about 1.5 seconds) while
the last program is being played, the
instant replay mode is cancelled.
When the seek tuning button (
pressed for 1.5 seconds or longer, the
program is fast-forwarded while the
button is being pressed. When pressing
and holding the button until the end of the
program, the instant replay mode is
cancelled.
When the instant replay button (
pressed again, playback is paused, or
playback starts if it has been paused.
Instant replay (PAUSE)
If the instant replay button (
pressed while the instant replay mode is
off, instant replay mode is turned on in a
paused condition (PAUSE). Press the
instant replay button (
resume playback from the point at which
it was paused.
NOTE
If the channel is changed, the instant replay
l
buffer data is deleted.
After turning on the power and switching to
l
SIRIUS digital satellite radio mode, the
instant replay mode is not available for
several seconds after changing channels.

Displaying the SIRIUS ID (ESN)

When the ESN button (
for 1.5 seconds or longer, or the manual
tuning dial is turned to channel 0, a 12-
digit Electronic Serial Number (ESN) for
the SIRIUS tuner is displayed.
Form No.8CG3-EA-11J
) is
(If the SIRIUS ID (ESN) for the tuner
does not display)
If ESN
pressing the ESN button (
seconds or longer, contact an Authorized
Mazda Dealer.

Initialization of ID code

) is
If the registered ID code is forgotten,
return the ID code to the default [0000] by
performing the following steps:
Setting condition: SAT mode

(Master code input preparation)

) is
1. Press and hold the auto memory button
) is
2. ENTER PIN appears for two seconds
) again to
3. SR1 - - - - appears, which indicates
(Master code input)
4. Input the master code using the channel

(Master code input determination)

5. Determine the master code which has
) is pressed
6. PIN CLEARED appears which
7. The ID code is set to the default [0000]
Black plate (277,1)
Audio System
FAIL is displayed after
( ), then press channel preset
button 4. Hold both buttons together
for 1.5 seconds.
which indicates that it is in code input
mode.
that it is ready for code input.
preset buttons 1-4.
(The master code is already set at the
time of factory shipment.)
been input by pressing the auto
memory button (
indicates that the master code input has
been completed.
and the initialization process is
completed.
Interior Comfort
) for 1.5
).
6-39