Omniview Ip Central Access Appliance 5000Hq - Belkin OmniView 5216K User Manual

Web InTeRfaCe
sections
table of contents
lan
Under LAN in Figure 14, is the following:
enable dHCP – When a DHCP server is active on the same network
to which the Switch is connected, DHCP provides automatic IP
assignment.
When dHCP is disabled (Recommended) – You can assign a fixed IP
address to Switch.
Consult your network administrator regarding the use of the DHCP.
When DHCP is disabled, enter the IP address, subnet Mask, and
default Gateway for lan, as given by your network administrator.
These parameters can be configured locally from the OSD as explained
on page 14.
OmniViewIP 5216K/5232K
1 2 3 4

OmniView IP Central access appliance 5000HQ

OmniView IP 5000HQ is a centralized, IP-based system for secure
control of servers and network devices, power, and user administration
in the datacenter environment. The 5000HQ combines out-of-band,
KVM-via-IP access with modern IT standards and requirements. It is the
most comprehensive remote server maintenance solution available in
the market today.
enable OmniView IP 5000HQ – Check this option to allow the Switch
to be remotely managed by Central Manager Appliance 5000HQ.
Manager auto discovery – When checked, 5000HQ automatically
detects the Switch if it resides on the same network segment.
Manager IP – If the Switch resides on a different segment, type the
static IP address of the 5000HQ management appliance. (We advise
typing the static IP address of the 5000HQ management appliance even
if the Switch resides on the same network segment as the 5000HQ
management appliance.)
18
6
5