Ap27 Connection; Rc36 Rate Compass Installation - Simrad AP25 Manual

Connect to
any of the two
Robnet2
connectors
J1 and J2 (top) are Robnet2 connectors. J3 and J4 are SimNet
connectors.

AP27 connection

If a Simrad AP27 is part of the system, use the JP27 Jack Point
and connect as shown on Figure 3-9. Alternatively cut the
connector from the cable and connect the wires in parallel with
the cable shown on Figure 3-11 using the same color code.
The AP27 cable contains an air-breathing tube. Check that the
Note !
tube is open after you have cut the cable.

3.13 RC36 Rate Compass installation

The heading sensor is the most important part of the AP25
system and great care should be taken when deciding the
20221495F
AP25
CONTROL UNIT
REAR VIEW
J1 J3
J4
J2
Figure 3-11 Control unit connection
Figure 3-12
RC36 mounting
AUTOPILOT COMPUTER
MAIN PCB
Installation
TB15
Bn
Wh Pnk Gry Yel
ROBNET
79