Advanced Connecting; Connecting The Remote Control Jacks - Marantz SR5400 User Manual

ADVANCED CONNECTING

R L
DVD AUDIO PLAYER
or
ANTENNA COMPONENT VIDEO
DVD
SACD MULTI CHANNEL PLAYER
C C
Y B / R / Y
P B P R
FM (75Ω) GND AM
VIDEO
TV DVD VCR1 DSS/VCR2 MONI.
TV DVD IN
IN OUT IN OUT OUT
RC-5
DIGITAL IN DIGITAL OUT
IN L L
OPT. COAX.
1 2 3 4
CENTER
L
OUT R R
TV DVD VCR1 DSS/VCR2 CD TAPE CDR/MD
R
L
SURR. SUB
FRONT SURR.
BACK WOOFER
R
IN OUT IN OUT IN OUT IN
AUDIO
R L R L
CONNECTING MULTI CHANNEL AUDIO SOURCE
The 6.1CH INPUT jacks are for multichannel audio
source such as a SACD multichannel player, DVD
audio player or external decoder.
If you use these jacks, switch on the 6.1CH INPUT
and set the 6.1CH INPUT level by using the SETUP
MAIN MENU. See page 19.
14
R L
R L R L
DSS/VCR2 MONI.OUT
C C C C
B / R / Y B / R /
P B P R P B P R
L
AC IN
S-VIDEO
VCR1 DSS/VCR2
OUT IN OUT MONI.OUT
R
FRONT SURR.
SL SL C C
PRE PRE
OUT OUT
POWER
AMPLIFER
SR SR SB SB SW SW
L L SL SL C C
R L
6.1CH 6.1CH
IN IN
Subwoofer
FRONT
OUT R R SR SR SB SB SW SW
SPEAKER SYSTEMS
6 - 8 OHMS
L R L R
Front
Left
Surround
Left
CONNECTING AN EXTERNAL POWER AMPLIFIER
The PREOUT jacks are for connecting external
power amplifiers.
Be sure to connect each speaker to the corresponding
external power amplifier.

CONNECTING THE REMOTE CONTROL JACKS

ANTENNA
FM (75Ω) GND AM
VIDEO
TV DVD VCR1 DSS/VCR2
IN OUT IN
DIGITAL IN
1 2 3 4
SERIAL NO.
CENTER
TV DVD VCR1 DSS/VCR2
L
R
SURR. SUB
IN OUT IN
BACK WOOFER
AC OUTLETS
UNSWITCHED
100W MAX.
R L
SURROUND
CENTER SURROUND
BACK REMOTE
CD RECORDER
CONTROL
IN
OUT
Front
EXTERNAL INTERNAL
Center
Right
Surround
Right
Surround Back
q
You can control other Marantz products through
this unit with the remote control by connecting the
REMOTE CONTROL terminals on each unit.
The signal transmitted from the remote control is
received by the remote sensor on this unit. Then the
signal is sent to the connected device through this
terminal. Therefore you only need to aim the remote
at one unit. Also, if a Marantz power amplifier (some
models excluded) is connected to one of these
terminals, the power amplifier's, power switch is
synchronized with this unit's power switch.
Set the REMOTE CONTROL SWITCH on the units,
other than the main unit to EXT.(EXTERNAL) for
this feature.
COMPONENT VIDEO
DVD DSS/VCR2 MONI.OUT
Y C B / C R / Y C B / C R / Y C B / C R /
P B P R P B P R P B P R
S-VIDEO
VCR1 DSS/VCR2
MONI.
TV DVD IN OUT IN OUT MONI.OUT
OUT OUT
2
RC-5 RC-5
DIGITAL OUT
IN IN L SL C
PRE
OPT. COAX.
OUT
OUT OUT R SR SB SW
CD TAPE CDR/MD L SL C
6.1CH
IN
OUT IN OUT IN OUT R SR SB SW
AUDIO
1
MD DECK
REMOTE
CONTROL
IN
OUT
EXTERNAL INTERNAL
w
Whenever external infrared sensors or similar
devices are connected to RC-5 IN of the SR5400,
be sure to always disable operation of the infrared
sensor on the main unit by using the following
procedure.
1.
Hold down the SELECT button and TV button
on the front panel at the same time for five
seconds.
2.
The setting "IR=ENABLE" is shown on the FL
DISPLAY.
3.
Press the SELECT button to change this to
"IR=DISABLE".
4.
Press the ENTER button. Once this setting is
made, the infrared sensor on the main unit is
disabled.
Note:
Be sure to set to "IR=ENABLE" when external
infrared sensors or similar devices are not
connected. Otherwise, the main unit will be
unable to receive remote control commands.
5.
To restore the original setting, perform steps 1
to 4 to set to "IR=ENABLE".
SERIAL NO.
AC IN
AC OUTLETS
UNSWITCHED
100W MAX.
RC OUT
OPTION
R L R L
SURROUND
FRONT CENTER SURROUND
BACK
SPEAKER SYSTEMS
6 - 8 OHMS
REMOTE CD PLAYER
CONTROL
IN
OUT
EXTERNAL INTERNAL